Parameter Selection

CAUTION:

NOTE:

When a VDCCM is replaced with a replacement, use this function to select and register parameters to the VDCCM.
For confirmation of applied models, refer to IDENTIFICATION attached to the vehicles.
If a wrong applied model is written, it can be rewritten.
When no data is registered, ABS/EBD/VDC warning light illuminates and the DTC "Parameter selection error" is detected.

Connect the Subaru Select Monitor.
On the «Main Menu» display, select the {Each System Check}.
On the «System Selection Menu» display, select the {Brake Control System}.
Click the [OK] button after the {VDC} is displayed.
On the «Brake Control Diagnosis» display, select the {Selection of Parameter}.
Check the applied model indicated in the "Model number plate". Refer to IDENTIFICATION , Identification.
Enter the applied model of 7-digit alphanumeric characters and press the [Enter] key.
When the confirmation screen indicating the vehicle information appears, check that the correct applied model and grade are displayed and click the [OK] button.
NOTE: When the displayed applied model and grade are different from those of the vehicle, perform registration operations again after clicking the [OK] button.
Execute Clear Memory after parameter selection and registration operations because the DTC for "Parameter selection error" is memorized.