Rear Door Glass: Removal

Remove the rear door trim.
Ref. to REMOVAL , Door Trim.
Remove the sealing cover. Ref. to REMOVAL , Rear Sealing Cover.
Remove the stabilizers.

Fig 1: Identifying Stabilizers
Courtesy of SUBARU OF AMERICA, INC.
Remove clips (A), and remove the front end and rear end of the weather strip.

Fig 2: Identifying Weather Strip Clips
Courtesy of SUBARU OF AMERICA, INC.
Remove the two screws to remove the weather strip outer.

Fig 3: Locating Weather Strip Outer Screws
Courtesy of SUBARU OF AMERICA, INC.
Connect the ground cable to battery and power window switch connector.
Operate the power window switch to move the glass to the position shown in the figure, then remove the two nuts through the service holes.

Fig 4: Locating Power Window Switch Nuts
Courtesy of SUBARU OF AMERICA, INC.
Remove the rear sash retaining nuts (A) and move the rear sash (B) rearward.

Fig 5: Identifying Rear Sash Retaining Nuts And Rear Sash
Courtesy of SUBARU OF AMERICA, INC.
Remove the door glass.
CAUTION:
- Since the gear may be disengaged, do not turn regulator in the closing direction after removing glass.
- Avoid impact and damage to the glass.