Reverse Check Cable: Removal

Set the vehicle on a lift.
Remove the gear shift knob.
Remove the console box front. Ref. to REMOVAL , Console Box.
Remove the clamp.

Fig 1: Identifying Boot And Insulator Assembly
Courtesy of SUBARU OF AMERICA, INC.
Remove the boot and insulator assembly.

Fig 2: Identifying Boot And Insulator Assembly With Clamp
Courtesy of SUBARU OF AMERICA, INC.
Remove the spring pin from the slider.

Fig 3: Identifying Spring Pin On Slider
Courtesy of SUBARU OF AMERICA, INC.
Remove the slider and spring.

Fig 4: Identifying Slider And Spring
Courtesy of SUBARU OF AMERICA, INC.
Cut the band clip, and separate the reverse check cable from the gear shift lever.

Fig 5: Locating Band Clip
Courtesy of SUBARU OF AMERICA, INC.
Lift up the vehicle.
Remove the under cover.
Remove the rear exhaust pipe and muffler. Ref. to REMOVAL , Rear Exhaust Pipe, and ref. to REMOVAL , Muffler.
Remove the heat shield cover.

Fig 6: Identifying Heat Shield Cover
Courtesy of SUBARU OF AMERICA, INC.
Remove the crossmember. Ref. to REMOVAL , Transmission Mounting System.
Remove the snap pin and washer, and separate the reverse check cable from the reverse check lever.

Fig 7: Identifying Reverse Check Cable With Snap Pin And Washer
Courtesy of SUBARU OF AMERICA, INC.
Move the transmission to the right side, and remove the stay bolts and the reverse check cable.
NOTE: If the transmission is not moved aside, the stay bolts may contact the body and cause damage.

Fig 8: Identifying Stay And Stay Bolt
Courtesy of SUBARU OF AMERICA, INC.
Lift up the stay clip, and separate the stay from the reverse check cable.

Fig 9: Identifying Reverse Check Cable And Clip
Courtesy of SUBARU OF AMERICA, INC.
Pull out the reverse check cable from underside of the vehicle to remove it.
NOTE: Be careful not to damage the inner boot.
Loosen the lock nut, and remove the reverse check cable from the cable plate.

Fig 10: Identifying Reverse Check Cable And Cable Plate
Courtesy of SUBARU OF AMERICA, INC.