Crankshaft Position Sensor (Method With Oscilloscope)

Prepare an oscilloscope.
Remove the lower inner trim of passenger's side. Ref. to REMOVAL , Lower Inner Trim.
Turn over the floor mat of passenger's seat.
Remove the protect cover.

Fig 1: Locating Protect Cover Bolts
Courtesy of SUBARU OF AMERICA, INC.
Remove the nuts and bolts which hold the ECM to the bracket.

Fig 2: Locating ECM Bracket Bolts And Nuts
Courtesy of SUBARU OF AMERICA, INC.

Connect the probe to ECM connector.

Fig 3: Connecting Probe To ECM Connector

Courtesy of SUBARU OF AMERICA, INC.

ECM CONNECTOR TERMINAL REFERENCE CHART

Terminal No.	Probe
13	+
14	-

Start the engine and let it idle.
Check the pattern is as same as the waveform and voltage shown below.

Fig 4: Voltage Waveform
Courtesy of SUBARU OF AMERICA, INC.