Reduction Driven Gear: Removal

1. Remove the transmission assembly from vehicle body. Refer to REMOVAL , Automatic Transmission Assembly.
2. Remove the rear wheel speed sensor, and separate the extension case from transmission case. Refer to REMOVAL , Extension Case.
3. Set the range select lever to the "P" range.
4. Lift the crimped section, and then remove the lock nut.
   Fig 1: Removing Lock Nut

   Courtesy of SUBARU OF AMERICA, INC.
5. Using the ST1 and ST2, extract the reduction driven gear.

ST1 499737000 PULLER

ST2 899524100 PULLER SET

Fig 2: Removing Reduction Driven Gear

Courtesy of SUBARU OF AMERICA, INC.