LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2009 >> Forester XT >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Automatic Transmission 4AT (Diagnostics) >> Learning Control >> Procedure >> Preparation For Learning

Preparation For Learning

  1. Warm-up or cool down until the ATF temperature displayed on the Subaru Select Monitor reaches 60 - 80°C (140 - 176°F).
  2. Shift the select lever to "P" range.
  3. Fully apply the parking brake.
  4. Lift up the vehicle.
    CAUTION: Be sure to keep the lowest edge of the tires 30 cm or more off the ground because the vehicle vibrates during the work.
  5. Connect the Subaru Select Monitor to the data link connector.
  6. Turn the ignition switch to ON.
  7. Turn OFF all switches, which produce an electrical load, including headlight, air conditioner, seat heater, rear defogger, etc.
  8. Turn the ECO switch to ON for model with ECO switch. Turn the SPORT mode switch to OFF for model with SPORT mode. Turn the POWER/HOLD switch to OFF for model with POWER/HOLD switch. Set to I mode for model with SI-DRIVE.
NOTE: Error message is not displayed even when an incorrect mode is set. While the operation is continued, "AT learning promoting" is displayed, but it cannot end normally. If the message does not change after 2 minutes have passed, retry "AT learning mode" from the beginning.
scientia non olet · About LEMON Manuals