LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2009 >> Forester X, Automatic >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Anti-Theft System - Security And Locks >> Security System >> Inspection >> Check Horn

Check Horn

DIAGNOSIS PROCEDURE CHART

Step Check Yes No
1 CHECK HORN OPERATION  .
Check the horn sounds when the horn switch is pushed.		 Does the horn sound? Go to step 2  . Check the horn circuit.
2 CHECK OUTPUT TO HORN RELAY  .
  1. Connect the Subaru Select Monitor Kit.
  2. Turn the ignition switch to ON (engine OFF), and run the "PC application for Subaru Select Monitor".
  3. On the "System Selection Menu", select {Integ. unit mode}.
  4. Select {Function Check}.
  5. Select {Horn Output} and execute
 Does the horn sound? Horn circuit is OK. Go to step 3  .
3 CHECK HORN RELAY CIRCUIT  .
  1. Turn the ignition switch to OFF.
  2. Disconnect the harness connector of body integrated unit.
  3. Disconnect the main fuse box harness connector (B186).
  4. Measure the resistance between harness connector terminals.

Connector & terminal 
(B279) No. 29 - (B186) No. 1: 		 Is the resistance less than 10 Ω? Check the body integrated unit. Refer to BASIC DIAGNOSTIC PROCEDURE . Repair or replace the harness.
scientia non olet · About LEMON Manuals