Clear Memory Mode

Check that the select lever is in "P" range.
On the « Main Menu » display screen, select the {Each System Check}.
On the « System Selection Menu », select {Transmission}.
After transmission type information pops up, select [OK].
On the « Transmission Diagnosis », select {Clear Memory}.
When the "Done. Turn ignition switch to OFF" pops up, select [OK].
Turn Subaru Select Monitor and ignition switch to OFF. To turn the ignition switch to ON again, wait for more than 10 seconds.
NOTE:
- To clear the previous DTC, use {Clear Memory}, and to clear the learned value, use {Clear Memory 2}.
- For details concerning the operation procedure, refer to the « PC application for Subaru Select Monitor ».