Oil Pump: Removal

Disconnect the ground cable from the battery.
Remove the air intake duct. <Ref. to REMOVAL , Air Intake Duct.>
Remove the pulley belt cover.
Remove the V-belts.
Disconnect the connector from power steering pump switch.
Disconnect the pressure hose and suction hose from power steering pump.
CAUTION:
- Do not spill power steering fluid.
- To prevent foreign matter from entering the hose and pipe, cover the open ends with clean cloth.
  
  Fig 1: Identifying Suction Pipe And Pressure Hose
  Courtesy of SUBARU OF AMERICA, INC.
Remove the installation bolt of the power steering pump bracket.

Fig 2: Identifying Power Steering Pump Bracket Bolts
Courtesy of SUBARU OF AMERICA, INC.
Place the oil pump bracket in a vise, and remove the two bolts from the front side of the oil pump.
CAUTION: When securing the oil pump bracket in a vice, hold the oil pump bracket with the least possible force between two pieces of wood.

Fig 3: Locating Oil Pump Bracket
Courtesy of SUBARU OF AMERICA, INC.
Remove the bolt from the rear side of oil pump.

Fig 4: Locating Oil Pump Bolt
Courtesy of SUBARU OF AMERICA, INC.
Disassemble the oil pump and bracket by inserting a flat tip screwdriver as shown in the figure.

Fig 5: Locating Oil Pump And Bracket
Courtesy of SUBARU OF AMERICA, INC.