LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Tribeca Base >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Airbag System >> Curtain Airbag Module >> Removal

Curtain Airbag Module: Removal

CAUTION: Refer to "CAUTION" of "General Description" before handling the airbag module. < Ref. to CAUTION , General Description.>
  1. Turn the ignition switch to OFF.
  2. Disconnect the ground cable from battery and wait for at least 20 seconds before starting work.
  3. Remove the front pillar upper trim and center pillar upper trim. < Ref. to FRONT PILLAR UPPER TRIM , REMOVAL, Side Trim.> < Ref. to CENTER PILLAR UPPER TRIM , REMOVAL, Side Trim.>
  4. Remove the rear quarter trim. < Ref. to REMOVAL , Rear Quarter Trim.>
  5. Remove the roof trim. < Ref. to REMOVAL , Roof Trim.>
  6. Disconnect the connector from curtain airbag module.
  7. Remove the bolts, and then remove the curtain airbag module.
    CAUTION:
    • Be careful not to damage the curtain airbag module during removal.
    • Never open the curtain airbag module before deploying it. Never reuse the deployed curtain airbag module.
      Fig 1: Locating Curtain Airbag Module
      G05346935Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the front piller from front pillar pad.
    Fig 2: Locating Front Piller From Front Pillar Pad
    G05033180Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals