LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Tribeca Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Engine (Diagnostics) (H6DO) >> Drive Cycle >> Procedure >> Drive Cycle H

Drive Cycle H

  1. Perform the Clear Memory Mode. <Ref. to CLEAR MEMORY MODE .>
  2. With the ignition switch ON, read the engine coolant temperature, intake air temperature and fuel temperature. <Ref. to READ CURRENT DATA FOR ENGINE (NORMAL MODE) , OPERATION, Subaru Select Monitor.>
  3. If the values from step  2) satisfy the following two conditions, start the engine.

    Condition: 

    Engine coolant temperature - intake air temperature ≤ 5°C (41 °F) 

    Engine coolant temperature - fuel temperature ≤ 2°C (36°F) 

    NOTE:
    • If the conditions are not satisfied, turn the ignition switch to OFF and wait until the parameters are satisfied.
    • Start AT vehicles in the P range, and MT vehicles in the N position.
    • Idle the engine for 1 minute under the conditions in step  2).

    Do not disconnect the battery terminals while diagnosing. (Data will be cleared by disconnecting the battery terminals.)

    DRIVE CYCLE H REFERENCE CHART

    DTC Item Condition
    *P1602 ECM Error (Cold Start) -
scientia non olet · About LEMON Manuals