LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Outback XT Limited, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Intake System - Intake (Induction) (H4SO)) >> Air Cleaner Element >> Removal

Air Cleaner Element: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground cable from the battery.
    Fig 1: Disconnecting Ground Cable From Battery
    G05019586Courtesy of SUBARU OF AMERICA, INC.
  2. Disconnect the connector from mass air flow and intake air temperature sensor.
    Fig 2: Locating Connector From Mass Air Flow And Intake Air Temperature Sensor
    G05016961Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the clip (A) securing upper side of air cleaner case.
    Fig 3: Identifying Clip Securing Upper Side Of Air Cleaner Case
    G05016962Courtesy of SUBARU OF AMERICA, INC.
  4. Pull the air cleaner case (rear) backward of the vehicle, and remove the air cleaner element.
    NOTE: Be careful of the power steering hose fixed to the bottom of the air cleaner case (rear).