LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Outback R L.L. Bean Edition >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Engine (Diagnostics) (H6DO) >> System Operation Check Mode >> Operation >> Idle Speed Control

Idle Speed Control

CAUTION: After executing the operation check mode, execute the Clear Memory Mode. < Refer to OPERATION , Clear Memory Mode. >
  1. On the «System operation check mode» display screen, select the {Idle Speed Control}.
  2. On the «Start the Engine» display screen, start the engine and click the [OK] button.
  3. In the «Idle Engine Speed Control» screen, click the [↑] button or the [↓] button to change the setting values, then click the [OK] button.

    Setting is possible in a range between 500 rpm - 2000 rpm, in increments of 50 rpm. However, the engine speed that can actually be controlled will vary depending on the vehicle or auxiliary load condition.

  4. Click the [Cancel] button to end the idle speed control. The screen will return to the «System Operation Check Mode» screen.
    NOTE: For detailed operation procedure, refer to the "PC application help for Subaru Select Monitor".
scientia non olet · About LEMON Manuals