Front Stabilizer: Installation

WARNING: This page is about a different car, the 2007 Subaru Outback and 2007 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal.

NOTE:

Use a new self-locking nut.
Ensure the stabilizer bushing and stabilizer have the same identification colors.
Install the stabilizer bushing (front crossmember side) while aligning it with the paint mark on stabilizer.
The stabilizer bracket has a set orientation. Install it with the arrow mark facing the upper side of the vehicle.

Fig 1: Identifying Stabilizer Bracket
Courtesy of SUBARU OF AMERICA, INC.

Tightening torque:

Stabilizer link:

45 N.m (4.6 kgf-m, 33.2 ft-lb)

Stabilizer bracket:

25 N.m (2.5 kgf-m, 18.1 ft-lb)