Intake Manifold: Disassembly

WARNING: This page is about a different car, the 2007 Subaru Outback. However, it is still accessible from the selected car via links, so may be relevant.

Remove the engine harness from intake manifold.
Remove the throttle body. <Ref. to REMOVAL , Throttle Body .>
Remove the pressure regulator vacuum hose from the intake manifold.

Fig 1: Locating Pressure Regulator Vacuum Hose And Intake Manifold
Courtesy of SUBARU OF AMERICA, INC.
Remove the manifold absolute pressure sensor. <Ref. to REMOVAL , Manifold Absolute Pressure Sensor .>
Remove the purge control solenoid valve. <Ref. to REMOVAL , Purge Control Solenoid Valve .>
Loosen the clamp which holds fuel injector pipe to the fuel hose, and then disconnect the pipe from fuel hose.

Fig 2: Locating Fuel Injector Pipe To Fuel Hose And Clamp
Courtesy of SUBARU OF AMERICA, INC.
Remove the bolts which install fuel pipes on intake manifold.

Fig 3: Locating Fuel Pipes, Intake Manifold And Bolts
Courtesy of SUBARU OF AMERICA, INC.

Fig 4: Locating Intake Manifold And Bolts
Courtesy of SUBARU OF AMERICA, INC.