Confirmation Of Current Setting

WARNING: This page is about a different car, the 2007 Subaru Outback and 2007 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

On the «Main Menu» display screen, select {Each System Check}.
On the «System Selection Menu» display screen, select the {Integ. unit mode}.
On the «Integ. unit mode failure diag» display screen, select the {Current Data Display & Save}.
On the «Current Data Display & Save» display screen, select the {12 Data Display}.
Using the scroll key, scroll the display screen up or down until the desired data is shown.

Display the following item and record the settings.

Required items for new registration (Except for system not equipped)

CONFIRMATION OF CURRENT DATA CHART

Contents	Item to confirm				Remarks
Key No. to register	1	2	3	4	Registered ID type
Off delay	OFF	Long	Normal	Short	Setting for lighting off time
Auto-lock	60, 50, 40, 30, 20		OFF		Not supported by North American specifications (Unit sec.)
Outside Temp Offset	-2°C - +2°C (0.5°C increments)				Adjustment of outside temperature
Rr defogger op. mode	Normal		Continuous		Normal: Off at 15 minutes of operation Continuous: Operations from switch on to off
Wiper deicer op. mode	Normal		Continuous		Normal: Off at 15 minutes of operation Continuous: Operations from switch ON to OFF, repeats ON for 15 minutes, OFF for 2 minutes
Security Alarm Setup	ON		OFF		ON: Warning device operation possible OFF: Warning device does not operate
Impact Sensor Setup	ON		OFF		ON: Impact sensor operation possible OFF: Impact sensor does not operate Turn OFF for vehicles not equipped with an Impact Sensor
Alarm monitor delay setting	ON		OFF		ON: Monitor after a fixed period of time from reception of the keyless lock signal OFF: Monitor after reception of the keyless lock signal
Lockout prevention	ON		OFF		ON: Lockout prevention operation OFF: Lockout prevention not operated
Impact Sensor	Yes		No		Yes: Impact sensor equipped No: Impact sensor not equipped Always set to no for vehicles not equipped with the impact sensor.
Siren setting	Yes		No		Not supported by North American specifications The horn does not honk when the warning function operates, if the vehicle not equipped with a siren is set to 'Yes'.
Answer-back buzzer setup	ON		OFF		ON: Answer-back buzzer operation possible OFF: Answer-back buzzer not operated
Hazard answer-back setup	ON		OFF		ON: Hazard answer-back buzzer operation possible OFF: Hazard answer-back buzzer not operated
Automatic locking setup	ON		OFF		Not supported by North American specifications
Ans.-back Buzzer	Yes		No		Yes: Vehicle equipped with answer-back buzzer No: Vehicle not equipped with answer-back buzzer
Auto locking	Yes		No		Not supported by North American specifications
Passive arming	ON		OFF		ON: Passive arming operation possible OFF: Passive arming not in operation
Belt warning Switch	ON		OFF		ON: All alarms except the first stage not in operation OFF: Belt alarm operation possible
Door open warning (prevention of battery run-out)	Yes		No		Yes: Door interlocked room light goes off when on for 10 minutes consecutively when door is open. No: Room light remains illuminated until door is closed.
A/C ECM setting	Yes		No		Set models with auto A/C to YES.
P/W ECM setting	Yes		No		Not supported by North American specifications
Center display failure	Yes		No		Yes: Navigation display equipped vehicles No: Vehicles not equipped with Navigation displays
Wiper deicer	Yes		No		Yes: Vehicle equipped with wiper deicer No: Vehicle not equipped with wiper deicer
Rear fog light setting	Yes		No		Not supported by North American specifications
Factory initial setting	Factory		Market		Do not change to the factory mode. Set to market when using normally.