LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Outback Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 76 (LAN System (Diagnostics)) >> Basic Diagnostic Procedure >> Procedure >> With SUBARU Select Monitor

With SUBARU Select Monitor

WARNING: This page is about a different car, the 2007 Subaru Outback and 2007 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Subaru Select Monitor is required for reading DTC, performing diagnosis and reading current data.
  • Remove foreign matter (dust, water, oil, etc.) from the body integrated unit connector during removal and installation.
  • For model with immobilizer, registration of immobilizer may be needed after the replacement of controller etc. For detailed procedure, refer to the REGISTRATION MANUAL FOR IMMOBILIZER .
NOTE:
  • To check harness for open or short circuits, shake the suspected trouble spot or connector.
  • Check List for Interview <Ref. to CHECK LIST FOR INTERVIEW . >
DIAGNOSTIC PROCEDURE CHART

Step Check Yes No
1 CHECK PRE-INSPECTION. 
  1. Ask the customer when and how the trouble occurred using the interview check list. <Ref. to CHECK LIST FOR INTERVIEW . >
  2. Check the display of communication error display, (combination meter, odometer/trip meter) (except meters with MID)
 Is the communication error displayed? Go to step 3  . Go to step 2  .
2 BASIC INSPECTION. 
Check components which might affect body control. <Ref. to INSPECTION  .>		 Is the component that might influence the body control problem normal? Go to step 3  . Repair or replace each component.
3 CHECK INDICATION OF DTC. 
  1. Read the DTC. <Ref. to READ DIAGNOSTIC TROUBLE CODE (DTC)  .>
    NOTE: If the communication function of the Subaru Select Monitor cannot be executed properly, check the communication circuit. <Ref. to COMMUNICATION FOR INITIALIZING IMPOSSIBLE  .>
  2. Record all DTC.
 Is DTC displayed? Go to step 5  . Go to step 4  .
4 PERFORM GENERAL DIAGNOSTICS. 
Inspect using the "General Diagnostics Table". <Ref. to GENERAL DIAGNOSTIC TABLE . >		 Is result of inspection OK? LAN system is normal. Go to step 5  .
5 PERFORM DIAGNOSIS. 
  1. Correct the cause of trouble.
  2. Perform Clear Memory Mode. <Ref. to CLEAR MEMORY MODE  .>
  3. Read the DTC. <Ref. to READ DIAGNOSTIC TROUBLE CODE (DTC)  .>
 Is DTC displayed? Repeat step 5 until DTC is not shown. Finish the diagnosis.
scientia non olet · About LEMON Manuals