Front Link: Installation

WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Using a transmission jack, support the rear arm horizontally.
Using new self-locking nuts, install the front link.

Fig 1: Supporting Rear Arm Horizontally
Courtesy of SUBARU OF AMERICA, INC.

CAUTION: Install the front link with the protrusion side faced to the front side of vehicle.

Fig 2: Installing Front Link
Courtesy of SUBARU OF AMERICA, INC.

NOTE: Inspect the wheel alignment and adjust it if necessary.

Tightening torque: 120 N.m (12.2 kgf-m, 89 ft-lb)