Display Of Status Information

WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Check the operating condition of each sensor in the event of malfunction in the seat belt buckle switch and seat position sensor, or when the seat belt buckle switch and seat position sensor has been replaced.

On the «Main Menu» display screen, select the {Each System Check} and press the [YES] key.
On the «System Selection Menu» display screen, select the {Airbag System} and press the [YES] key.
On the «Airbag System» display screen, select the {Status Data} and press the [YES] key. The following table is for support data.

ITEM DISPLAY CHART

Item

Display

Seat position sensor LH

Front position ⁽¹⁾/Rear position ⁽²⁾ /Other ⁽³⁾/lnitial setting ⁽³⁾ /- ⁽⁵⁾

Seat position sensor RH

- ⁽⁵⁾

Seat belt buckle switch LH

Belted ⁽⁶⁾/Unbelted⁽⁷⁾ /Other ⁽⁸⁾/lnitial setting ⁽⁴⁾ /- ⁽⁹⁾

Seat belt buckle switch RH

Belted ⁽⁶⁾/Unbelted⁽⁷⁾/Other ⁽⁸⁾/lnitial setting ⁽⁴⁾/- ⁽⁹⁾

Passenger's airbag control status

ON ⁽¹⁰⁾/OFF ⁽¹¹⁾ /Initial setting ⁽⁴⁾

⁽¹⁾	The seat position is forward.

⁽²⁾	The seat position is rearward.

⁽³⁾	Displayed when data other than before and behind the seat, such as the breakdown etc, is input.

⁽⁴⁾	Displayed when it is initial.

⁽⁵⁾	Seat position sensor not supported

⁽⁶⁾	Seat belt fastened

⁽⁷⁾	Seat belt not fastened

⁽⁸⁾	Displayed when data other than belt fastened or not fastened, such as breakdowns is input.

⁽⁹⁾	Seat belt buckle switch not supported

⁽¹⁰⁾	Passenger's airbag operating state

⁽¹¹⁾	Passenger's airbag non-operating state

NOTE: For details concerning operation procedures, refer to the "Subaru Select Monitor Operation Manual".