Data Display
WARNING: This page is about a different car, the 2006 Subaru Outback, 2006 Subaru Legacy, and 2006 Saab 9-2X. However, it is still accessible from the selected car via links, so may be relevant.
- On the «Main Menu» display screen, select {Each System Check} and press the [YES] key.
- On the «System Selection Menu» display screen, select the {Tire Pressure Monitor} and press the [YES] key.
- Press the [YES] key after the {Tire Pressure Monitor} is displayed.
- On the «Tire pressure monitor diagnosis» display screen, select the {Data Display}, and then press the [YES] key, then necessary data will be displayed.
- A list of the support data is shown in the following table.
- Data monitor (Analog) DATA MONITOR CHART
Display Contents to be monitored Unit of measure FR FN Code LEARN, LOW BAT, OFF, WAKE, RE ME, NORMAL LEARN: Transmitted transmitter ID using the transmitter registration tool
LOW BAT: Transmitter battery voltage running low
OFF: Transmitter function stops (no data transmission)
RE ME: Tire air changes ±8.4 kPa
WAKE: When data transmission is started from a stopped state.
NORMAL: Conditions other than aboveFL FN Code RR FN Code RL FN Code FR tire pressure Value converted to tire pressure from data delivered from transmitter is displayed.
(The figure may differ from the actual measured values.)kPa, psig, mmHg, inHg FL tire pressure kPa, psig, mmHg, inHg RR tire pressure kPa, psig, mmHg, inHg RL tire pressure kPa, psig, mmHg, inHg Vehicle Speed Vehicle speed signal which is input in control module. km/h, MPH Pressure warning Threshold where tire pressure warning light lights kPa, psig, mmHg, inHg Return pressure Threshold where tire pressure warning light goes out kPa, psig, mmHg, inHg