LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Outback Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Tire Pressure Monitoring System (Diagnostics)) >> Control Module I/O Signal >> Electrical Specification

Electrical Specification

WARNING: This page is about a different car, the 2006 Subaru Outback, 2006 Subaru Legacy, and 2006 Saab 9-2X. However, it is still accessible from the selected car via links, so may be relevant.
ELECTRICAL SPECIFICATION

Terminal No. Measured value Measuring condition Remarks
1 Select monitor communication Serial communication -
2 Tire pressure warning light output When malfunction occurs, or tire pressure decreases System failure: blinks
Tire pressure decreases: turns on
4 Speed sensor signal While driving (Pulse signal) Change according to vehicle speed
5 Ignition power supply IG switch ON (Battery voltage) -
6 Battery power supply Battery voltage Always
8 Body integrated unit (Hazard output signal). - When hazard turns on.
9 GND 0 V (Always) Always