LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Outback Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Manual Transmission And Differential 5MT) >> Main Shaft Assembly for Single-range >> Installation

Main Shaft Assembly for Single-range: Installation

WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the needle bearing and oil seal to the front of the transmission single-range main shaft assembly.
    NOTE:
    • Wrap the clutch splined section with vinyl tape to prevent damage to the oil seal.
    • Apply grease (UNILUBE #2 or equivalent) to the sealing lip of the oil seal.
    • Use a new oil seal.
  2. Install the transmission case knock pin into the knock pin hole of the needle bearing outer race.
    NOTE: Align the end face of the seal with surface (A) when installing the oil seal.
    Fig 1: Identifying Oil Seal
    G05003053
  3. Install the drive pinion assembly. < Ref. to INSTALLATION , Drive Pinion Shaft Assembly. >
  4. Install the transmission case. < Ref. to INSTALLATION , Transmission Case. >
  5. Install the transfer case together with the extension case assembly. < Ref. to INSTALLATION , Transfer Case and Extension Case Assembly. >
  6. Install the manual transmission assembly to the vehicle. < Ref. to INSTALLATION , Manual Transmission Assembly. >
scientia non olet · About LEMON Manuals