LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Outback Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Automatic Transmission 5AT) >> Drive Pinion Shaft Assembly >> Installation

Drive Pinion Shaft Assembly: Installation

WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Assemble the drive pinion assembly to oil pump cover.
    NOTE: Be careful not to bend the shim.

    Tightening torque: 

    70 N.m (7.1 kgf-m, 51.6 ft-lb) 

    Fig 1: Identifying Drive Pinion Shaft Assembly From Oil Pump Cover
    G05022351
  2. Adjust the tooth contact between drive pinion shaft assembly and the front differential side gear. < Ref. to ADJUSTMENT , Drive Pinion Shaft Assembly. >
  3. Join the converter case with the transmission case. < Ref. to INSTALLATION , Converter Case. >
  4. Install the transmission harness connector to the stay.
  5. Install the ATF filter pipe. < Ref. to INSTALLATION , ATF Filter. >
  6. Install the oil charge pipe with O-ring.
  7. Install the torque converter assembly. < Ref. to INSTALLATION , Torque Converter Assembly. >
  8. Install the transmission assembly to the vehicle. < Ref. to INSTALLATION , Automatic Transmission Assembly. >
scientia non olet · About LEMON Manuals