LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Outback Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Automatic Transmission 5AT) >> Converter Case >> Removal

Converter Case: Removal

WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transmission assembly from vehicle body. < Ref. to REMOVAL , Automatic Transmission Assembly. >
  2. Remove the torque converter assembly. < Ref. to REMOVAL , Torque Converter Assembly. >
  3. Remove the transmission harness connector from stay.
  4. Remove the turbine speed sensor 1. < Ref. to REMOVAL , Turbine Speed Sensor 1. >
  5. Remove the oil charge pipe. < Ref. to REMOVAL , Oil Charge Pipe. >
  6. Remove the ATF filter inlet and outlet pipes. < Ref. to REMOVAL , ATF Filter. >
  7. Remove the converter case attachment bolts.
  8. Lay along the transmission body, and then remove the oil pan.
  9. Remove the three converter case mounting bolts (TORX®).

    ST 18676AA020 TORX® WRENCH

    Fig 1: Identifying Converter Case Mounting Bolts
    G05022333
  10. Separate the converter case by lightly tapping with plastic hammer.
  11. Remove the differential assembly. < Ref. to REMOVAL , Front Differential Assembly. >
  12. Remove the oil seal from converter case.
scientia non olet · About LEMON Manuals