LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Outback Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Engine Controls - Engine (Diagnostics) (H4DOTC)) >> Subaru Select Monitor >> Operation >> Read Current Data For Engine (Normal Mode)

Read Current Data For Engine (Normal Mode)

WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. On the «Main Menu» display screen, select {Each System Check} and press the [YES] key.
  2. On the «System Selection Menu» display screen, select {Engine Control System} and press the [YES] key.
  3. Press the [YES] key after the information of engine type has been displayed.
  4. On the «Engine Diagnosis» display screen, select the {Current Data Display/Save}, and then press the [YES] key.
  5. On the «Display Menu» screen, select the {Data Display} and press the [YES] key.
  6. Using the scroll key, scroll the display screen up or down until the desired data is shown.
    • A list of the support data is shown in the following table.
SUPPORT DATA

Remarks Display Unit of measure Note (at idling)
Engine coolant temperature signal Coolant Temp. °C or °F 80 - 100°C or 176 - 212°F
A/F correction 1 A/F Correction #1 % -10 - +10%
A/F learning 1 A/F Learning #1 % -15 - +15%
Intake manifold absolute pressure Mani. Absolute Pressure mmHg, kPa, inHg or psig 220 - 275 mmHg, 29.5 - 37 kPa, 8.7 - 10 inHg or 4.2 - 5.3 psig
Engine speed signal Engine Speed rpm 630 - 770 rpm (Agree with the tachometer indication)
Meter vehicle speed signal Meter Vehicle Speed km/h or MPH 0 km/h or 0 MPH (at parking)
Ignition timing signal Ignition Timing deg 10 - 15 deg
Intake air temperature signal Intake Air Temp. °C or °F 20 - 50°C or 68 - 122°F
Intake air amount Mass Air Flow g/s or lb/m 2.1 - 3.1 g/s or 0.35 - 0.40 lb/m
Throttle opening angle signal Throttle Opening Angle % 2.0 - 2.4%
Rear oxygen sensor voltage Rear O2 Sensor V 0 -1.0 V
Battery voltage Battery Voltage V 12 - 15V
Mass air flow voltage Air Flow Sensor Voltage V 1.0 - 1.7 V
Injection 1 pulse width Fuel Injection #1 Pulse ms 1.2 - 2.2 ms
Knock sensor correction Knock Correction deg 0.0 deg
Acceleration opening angle signal Accel. Opening Angle % 0.0%
Primary supercharged pressure control signal Primary Control % 0.0%
Purge control solenoid duty ratio CPC Valve Duty Ratio % 0 - 25%
Generator duty ratio ALT Duty % 0 - 100%
Fuel pump duty ratio Fuel Pump Duty % 30 - 40%
AVCS advance angle amount RH VVT Adv. Ang. Amount R deg 5 deg
AVCS advance angle amount LH VVT Adv. Ang. Amount L deg 5 deg
Oil flow control solenoid valve duty RH (AVCS) OCV Duty R % 0 - 20%
Oil flow control solenoid valve duty LH (AVCS) OCV Duty L % 0 - 20%
Oil flow control solenoid valve current RH OCV Current R mA 40 - 100 mA
Oil flow control solenoid valve current LH OCV Current L mA 40 - 100 mA
A/F sensor current value 1 A/F Sensor #1 Current mA -20 - 20 mA
A/F sensor resistance value 1 A/F Sensor #1 Resistance Ω 27 - 35 mA
A/F sensor output lambda 1 A/F Sensor #1 - 1.0
A/F correction 3 A/F Correction #3 % 0.00%
Throttle motor duty Throttle Motor Duty % -5%
Throttle power supply voltage Throttle Motor Voltage V 12 - 15V
Sub throttle sensor voltage Sub-throttle Sensor V 1.5 V
Main throttle sensor voltage Main-throttle Sensor V 0.6 V
Sub accelerator sensor voltage Sub-accelerator Sensor V 1.1 V
Fuel tank pressure signal Fuel Tank Pressure mmHg, kPa, inHg or psig +8.8 mmHg, +1.2 kPa, +0.4 inHg or 0.2 psig
Fuel temperature signal Fuel Temp. °C or °F +28°C or 82°F
Main accelerator sensor voltage Main-accelerator Sensor V 1.0 V
Atmospheric pressure Atmospheric Pressure mmHg, kPa, inHg or psig -
Intake manifold relative pressure Mani. Relative Pressure mmHg, kPa, inHg or psig (Intake manifold absolute pressure - atmospheric pressure)
Memory vehicle speed Memorized Cruise Speed km/h or MPH -
Odd Meter Estimated Cumulative Driving Distance km -
Fuel level signal Fuel Level V 5.10
Tumble generator valve RH opening signal TGV Position Sensor R V 0.34
Tumble generator valve LH opening signal TGV Position Sensor L V 0.32
Exhaust temperature signal Exhaust Gas Temperature °C or °F 385°C or 725°F
#1 cylinder roughness monitor Roughness Monitor #1 - 0
#2 cylinder roughness monitor Roughness Monitor #2 - 0
#3 cylinder roughness monitor Roughness Monitor #3 - 0
#4 cylinder roughness monitor Roughness Monitor #4 - 0
AT/MT identification terminal AT Vehicle ID Signal - ON/OFF
Test mode terminal Test Mode Signal - U-check
Neutral position switch signal Neutral Position Switch - Neutral
Soft idle switch signal Soft Idle Switch Signal - Idling
Ignition switch signal Ignition Switch - ON input
Power steering switch signal P/S Switch - OFF input (At OFF)
Air conditioning switch signal A/C Switch - OFF input (At OFF)
Starter switch signal Starter Switch - OFF input
Rear oxygen monitor Rear O2 Rich Signal - Rich/Lean
Knocking signal Knock Signal - None
Crankshaft position sensor signal Crankshaft Position Sig. - Provided
Camshaft position sensor signal Camshaft Position Sig. - Provided
Rear defogger switch signal Rear Defogger SW - OFF input (At OFF)
Blower fan switch signal Blower Fan SW - OFF input (At OFF)
Light switch signal Light Switch - OFF input (At OFF)
A/C middle pressure switch signal A/C Mid Pressure Switch - OFF input (At OFF)
Air conditioner compressor relay output signal A/C Compressor Signal - OFF output (At OFF)
Radiator fan relay 1 signal Radiator Fan Relay #1 - OFF output (At OFF)
Radiator fan relay 2 signal Radiator Fan Relay #2 - OFF output (At OFF)
PCV hose assembly diagnosis signal Blow-by Leak Connector - Connected
Pressure control solenoid valve signal PCV Solenoid - OFF output (At OFF)
Tumble generator valve output signal TGV Output - None
Tumble generator valve drive signal TGV Drive - Opening direction
Drain valve signal Vent Control Solenoid - OFF output (At OFF)
AT coordinate retard angle demand signal Retard Signal from AT - None
AT coordinate fuel cut demand signal Fuel Cut Signal from AT - None
AT coordinate permission signal Torque Permission Signal - ON/OFF
ETC motor relay signal ETC Motor Relay - ON
Clutch switch signal Clutch Switch - OFF (At OFF)
Stop light switch signal Stop Light Switch - OFF (At OFF)
SET/COAST switch signal SET/COAST Switch - OFF (At OFF)
RES/ACC switch signal RESUME/ACCEL Switch - OFF (At OFF)
Brake switch signal Brake Switch - OFF (At OFF)
Main switch signal Main Switch - OFF (At OFF)
Integrated unit data reception Body Int. Unit Data - Provided
Integrated unit data update Body Int. Unit Count - Provided
Cruise control cancel switch signal CC Cancel SW - OFF (At OFF)
NOTE: For detailed operation procedure, refer to the "Subaru Select Monitor Operation Manual".