LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Outback Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (Fuel Injection (Fuel Systems) (H4DOTC)) >> Knock Sensor >> Installation

Knock Sensor: Installation

WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the knock sensor to the cylinder block.
    NOTE: The portion of the knock sensor cord that is pulled out must be positioned at a 60° angle relative to the engine rear.

    Tightening torque: 

    24 N.m (2.4 kgf-m, 17.4 ft-lb) 

    Fig 1: Identifying Knock Sensor Cord Position Angle
    G05017806
  2. Connect the knock sensor connector.
    Fig 2: Identifying Knock Sensor Connector
    G05017743
  3. Install the intercooler.

    < Ref. to INSTALLATION , Intercooler. >

  4. Connect the battery ground cable to the battery.
    Fig 3: Removing Collector Cover
    G05019586
  5. Install the collector cover.
scientia non olet · About LEMON Manuals