LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Outback Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (Fuel Injection (Fuel Systems) (H4DOTC)) >> Fuel Sub Level Sensor >> Installation

Fuel Sub Level Sensor: Installation

WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal.

NOTE:
  • Use a new gasket.
  • Make sure the sealing portion is free from fuel or foreign matter before installation.
  • Align the protrusion (A) of gasket with the position shown in the figure.
  • Align the protrusion (B) of fuel sub level sensor with the cutout on the upper plate of fuel sub level sensor.
  • Tighten the nuts and bolts to the specified torque in the order as shown in the figure.

Tightening torque: 

4.4 N.m (0.45 kgf-m, 3.2 ft-lb) 

Fig 1: Identifying Tightening Sequence Of Nuts And Bolts
G05016929
Fig 2: Locating Bolts
G05018575
scientia non olet · About LEMON Manuals