LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Outback Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (Fuel Injection (Fuel Systems) (H4DOTC)) >> Exhaust Temperature Sensor >> Installation

Exhaust Temperature Sensor: Installation

WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before installing exhaust temperature sensor, apply anti-seize compound only to the threaded portion of exhaust temperature sensor. This facilitates the next removal.
    CAUTION: Never apply anti-seize compound to protector of the exhaust temperature sensor.

    Anti-seize compound: 

    NEVER-SEEZ NS-165 or the equivalent 

  2. Install the exhaust temperature sensor.
    NOTE: Align the harness (A) of exhaust temperature sensor to the marking (B) of joint pipe, and tighten the screws.

    Tightening torque: 

    21 N.m (2.1 kgf-m, 15.2 ft-lb) 

    Fig 1: Aligning Harness Of Exhaust Temperature Sensor To Marking Of Joint Pipe
    G04989140
  3. Install the joint pipe.

    < Ref. to INSTALLATION , Joint Pipe. >

  4. Connect the battery ground cable to the battery.
    Fig 2: Removing Collector Cover
    G05019586
scientia non olet · About LEMON Manuals