Confirmation Of Current Setting
WARNING: This page is about a different car, the 2006 Subaru Outback, 2006 Subaru Legacy, and 2006 Saab 9-2X. However, it is still accessible from the selected car via links, so may be relevant.
- On the «Main Menu» display screen, select {Each System Check} and press the [YES] key.
- On the «System Selection Menu» display screen, select the {Integ. unit mode} and press the [YES] key.
- On the «Integ. unit mode failure diag» display screen, select the {Current Data Display & Save} and press the [YES] key.
- On the «Current Data Display & Save» display screen, select the {12 Data Display} and press the [YES] key.
- Using the scroll key, scroll the display screen up or down until the desired data is shown.
- Display the following item and record the settings.
Required items for new registration (Except for system not equipped)
CONFIRMATION OF CURRENT SETTING
| Contents | Item to confirm | REMARKS | |||
|---|---|---|---|---|---|
| Key No. to register | 1 | 2 | 3 | 4 | Registered ID type |
| Off delay | OFF | Long | Normal | Short | Setting for lighting off time |
| Auto-lock | 60, 50, 40, 30, 20 | OFF | Not supported by North American specifications (Unit sec.) |
||
| Rr defogger op. mode | Normal | Continuous | Normal: Off at 15 minutes of operation Continuous: Operations from switch on to off |
||
| Wiper deicer op. mode | Normal | Continuous | Normal: Off at 15 minutes of operation Continuous: Operations from switch ON to OFF, repeats ON for 15 minutes, OFF for 2 minutes |
||
| Security Alarm Setup | ON | OFF | ON: Warning device operation possible OFF: Warning device does not operate |
||
| Impact Sensor Setup | ON | OFF | ON: Impact sensor operation possible OFF: Impact sensor does not operate Turn OFF for vehicles not equipped with an Impact Sensor |
||
| Alarm monitor delay setting | ON | OFF | ON: Monitor after a fixed period of time from reception of the keyless lock signal OFF: Monitor after reception of the keyless lock signal |
||
| Lockout prevention | ON | OFF | ON: Lockout prevention operation OFF: Lockout prevention not operated |
||
| Impact Sensor | Yes | No | Yes: Impact sensor equipped No: Impact sensor not equipped Always set to no for vehicles not equipped with the impact sensor. |
||
| Siren setting | Yes | No | Yes: Vehicle equipped with siren No: Vehicle not equipped with siren The horn does not honk when the warning operates if the vehicle not equipped with a siren is set to 'Yes'. |
||
| Answer-back buzzer setup | ON | OFF | ON: Answer-back buzzer operation possible OFF: Answer-back buzzer not operated |
||
| Hazard answer-back setup | ON | OFF | ON: Hazard answer-back buzzer operation possible OFF: Hazard answer-back buzzer not operated |
||
| Automatic locking setup | ON | OFF | Not supported by North American specifications | ||
| Ans.-back Buzzer | Yes | No | Yes: Vehicle equipped with answer-back buzzer No: Vehicle not equipped with answer-back buzzer |
||
| Auto locking | Yes | No | Not supported by North American specifications | ||
| Door open warning (prevention of battery run-out) | Yes | No | Yes: Door interlocked room light goes off when on for 10 minutes consecutively when door is open. No: Room light remains illuminated until door is closed. |
||
| A/C ECM setting | Yes | No | Set models with auto A/C to YES. | ||
| P/W ECM setting | Yes | No | Not supported by North American specifications | ||
| Center display failure | Yes | No | Yes: Navigation display equipped vehicles No: Vehicles not equipped with Navigation displays |
||
| Wiper deicer | Yes | No | Yes: Vehicle equipped with wiper deicer No: Vehicle not equipped with wiper deicer |
||
| Rear fog light setting | Yes | No | Not supported by North American specifications | ||
| Factory initial setting | Factory | Market | Do not change to the factory mode. Set to market when using normally. | ||