LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Outback Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Instrumentation/Driver Information) >> Clock System >> Inspection >> Check Power Supply And Ground Circuit

Check Power Supply And Ground Circuit

WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSIS PROCEDURE

Step Check Yes No
1 CHECK CLOCK POWER SUPPLY. 
  1. Disconnect the clock harness connector.
  2. Measure the voltage between the clock harness connector and chassis ground.

    Connector & terminal 

    (i59) No. 10 (+) - Chassis ground (-): 

 Is the voltage more than 10 V? Go to step 2.  Check the harness for a open or short between the fuse and clock.
2 CHECK CLOCK GROUND CIRCUIT. 
  1. Turn the ignition switch to OFF.
  2. Measure the resistance between the clock harness connector and chassis ground.

    Connector & terminal 

    (i59) No. 6 - Chassis ground: 

 Is the resistance less than 10Ω Replace the clock body. Repair the wiring harness.
scientia non olet · About LEMON Manuals