Section 22 (Cooling System (H4SO)): Thermostat: Installation
WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
- Install a gasket to thermostat, and install the thermostat and gasket to water pump as a unit. Then, install the thermostat cover.NOTE:
- When reinstalling the thermostat, use a new gasket.
- The thermostat must be installed with the jiggle pin facing forward.
Tightening torque: 12 N.m (1.2 kgf-m, 8.9 ft-lb)
- Connect the radiator outlet hose to thermostat cover.
- Install the front exhaust pipe.
< Ref. to INSTALLATION , Front Exhaust Pipe. >
- Install the under cover.
- Lower the vehicle.
- Fill engine coolant. < Ref. to FILLING OF ENGINE COOLANT , REPLACEMENT, Engine Coolant. >