LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Outback Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 162 (Drive Shaft System) >> Front Drive Shaft >> Removal

Front Drive Shaft: Removal

WARNING: This page is about a different car, the 2008 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground cable from the battery.
  2. Lift up the vehicle, and remove the front wheels.
  3. Lift the crimped section of axle nut.
    Fig 1: Lifting Crimped Section Of Axle Nut
    G05032588Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the axle nut using a socket wrench while depressing the brake pedal.
    CAUTION: Remove the wheel before loosening the axle nut. Failure to follow this rule may damage the wheel bearings.
  5. Drain the transmission gear oil. (MT model)
  6. Drain the differential gear oil. (AT model)
  7. Remove the stabilizer link from front arm.
  8. Disconnect the front arm bail joint from the housing.
    Fig 2: Locating Front Arm Bail Joint
    G05032352Courtesy of SUBARU OF AMERICA, INC.
  9. Remove the front drive shaft assembly. If it is hard to remove, use ST1 and ST2.

    ST1 926470000 AXLE SHAFT PULLER

    ST2 28099PA110 AXLE SHAFT PULLER PLATE

    Fig 3: Removing Front Drive Shaft Assembly
    G05032595Courtesy of SUBARU OF AMERICA, INC.
  10. Using a bar, remove the front drive shaft from transmission.
CAUTION: Be careful not to allow the bar to damage holder area.
scientia non olet · About LEMON Manuals