B: Installation

WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Install the knock sensor to cylinder block.
NOTE: Extraction area of knock sensor cord must be positioned at a 60° angle relative to the engine rear.

Tightening torque:

24 N.m (2.4 kgf-m, 17.4 ft-lb)

Fig 1: Identifying Cylinder Block Front Side
Connect the knock sensor connector.

Fig 2: Identifying Knock Sensor Connector
Install the air intake chamber.
< Ref. to INSTALLATION , Air Intake Chamber. >
Connect the battery ground cable to the battery.

Fig 3: Connecting Battery Ground Cable