LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Outback Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Fuel Injection (Fuel Systems) (H4SO)) >> 3. Intake Manifold >> B: Installation

B: Installation

WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the intake manifold onto cylinder heads.
    NOTE: Use a new gasket.

    Tightening torque: 

    25 N.m (2.5 kgf-m, 18.1 ft-lb) 

    Fig 1: Locating Intake Manifold Bolts
    G04997342
  2. Connect the fuel hose and evaporation hose to the fuel pipe.
    NOTE: If fuel hoses are damaged, replace with new hoses.
  3. Install the EGR pipe to intake manifold.

    Tightening torque: 

    34 N.m (3.4 kgf-m, 24.6 ft-lb) 

    Fig 2: Identifying EGR Pipe
    G04997340
  4. Connect the connectors to camshaft position sensor.
    Fig 3: Identifying Camshaft Position Sensor Connector
    G04997339
  5. Connect the connector to the power steering pump switch (A).
  6. Connect the connector to the oil pressure switch (B).
    Fig 4: Identifying Connector From Oil Pressure Switch
    G05016750
  7. Connect the connector to crankshaft position sensor.
    Fig 5: Identifying Crankshaft Position Sensor
    G04997337
  8. Connect the knock sensor connector.
    Fig 6: Identifying Knock Sensor Connector
    G04997336
  9. Connect the connector to engine coolant temperature sensor.
    Fig 7: Identifying Connector For Engine Coolant Temperature Sensor
    G04997335
  10. Connect the PCV hose (A) to intake manifold.
  11. Connect the engine harness connectors (B) to bulkhead harness connectors.
    Fig 8: Identifying Engine Harness Connectors And PCV Hose
    G04997334
  12. Connect the brake booster hose (A).
    Fig 9: Identifying Brake Booster Hose
    G04997333
  13. Connect the engine coolant hoses (A) to throttle body.
    Fig 10: Identifying Engine Coolant Hoses
    G04997332
  14. Connect the spark plug cords to spark plugs.
  15. Install the generator. < Ref. to INSTALLATION , Generator. >
  16. Install the air intake duct, air cleaner case and air intake chamber. < Ref. to INSTALLATION , Air Intake Duct. > < Ref. to INSTALLATION , Air Cleaner Case. > < Ref. to INSTALLATION , Air Intake Chamber. >
  17. Install the fuse of fuel pump relay to the main fuse box.
  18. Connect the battery ground cable to the battery.
    Fig 11: Identifying Ground Cable From Battery
    G05019586
scientia non olet · About LEMON Manuals