Parameter Selection

CAUTION:

NOTE:

When a VDCCM is replaced with a replacement, use this function to select and register parameters to the VDCCM.
For confirmation of applied models, refer to the "Model number plate" attached to the vehicles. <Ref. to IDENTIFICATION , Identification.>
If a wrong applied model is written, it can be rewritten.
When no data is registered, ABS/EBD/VDC warning light illuminates and the DTC "Parameter selection failure" is detected.

Connect the Subaru Select Monitor III.
On the «Main Menu» display screen, select the {Each System Check}.
On the «System Selection Menu» display screen, select the {Brake Control}.
Select the [OK] after {VDC} is displayed.
On the "Brake Control Diagnosis" display screen, select the {Parameter Selection}.
Check the applied model indicated in the "Model number plate". <Ref. to IDENTIFICATION , Identification.>
Enter the applied model of 7-digit alphanumeric characters and select the [Enter].
When the confirmation screen indicating the vehicle information appears, check that the correct applied model and grade are displayed and select the "OK".
NOTE: When the displayed applied model and grade are different from those of the vehicle, perform registration operations again after selecting the "OK".
Execute Clear Memory after parameter selection and registration operations because the DTC for "Parameter selection failure" is memorized.