Display Of Analog Data
ANALOG DATA
| Items to be displayed | Unit of measure | Remarks | Note |
|---|---|---|---|
| BATT Voltage (Control) | 10 - 15 V | Body integrated unit input value | Always |
| BATT Voltage (BACK UP) | 10 - 15 V | Body integrated unit input value | Always |
| IG Power Supply Voltage | 10 - 15 V | Body integrated unit input value | Ignition switch ON |
| ACC voltage | 10 - 15 V | Body integrated unit input value | Ignition switch ACC |
| Illumination VR voltage | 0 - 5 V | Body integrated unit output value | Illumination volume input value |
| Illumi. output d-ratio | 0 - 100% | Body integrated unit input value | Small light ON Illumination volume is other than bright. |
| Ambient temp sensor V | 0 - 5 V | Body integrated unit output value | Ignition switch ON |
| Ambient temperature | -40 - 87.5°C | Body integrated unit output value | Ignition switch ON |
| Fuel level voltage | 0 - 8 V | Body integrated unit input value | Ignition switch ON |
| Fuel level resistance | 0 - 102.3 Ω | Body integrated unit input value | Ignition switch ON |
| Key-lock solenoid V | 6 - 12 V | Body integrated unit output value | Other than parking range Key warning switch ON |
| Number of regist. | 0 - 4 | Key No. to register | |
| Front Wheel Speed | km/h | CAN data input value | Reception from VDC module |
| VDC/ABS latest f-code | DTC display (Temporarily) | CAN data input value | It is normal when DTC is not been input even if this code is displayed. Reception from VDC |
| Blower fan steps | 0 - 2 levels | CAN data input value | 0: OFF, 1: Low, 2:2 levels or more Reception from air conditioner ECM (AUTO A/C model) |
| Fuel level resistance 2 | 0 - 102.3 Ω | CAN data output value | Reception from body integrated unit |
| Fuel consumption | cc/s | CAN data input value | Reception from ECM and transmission to center monitor |
| Engine coolant temperature | -40 - 130°C | CAN data input value | Reception from ECM |
| Vehicle lateral G | m/s2 | CAN data input value | Reception from VDC unit |
| SPORT Shift Stages | 0 - 7 levels | CAN data input value | (0: Light OFF; 1 - 5: Gear display; 6: Fail; 7: ATF temperature High/Low) Reception from TCM (AT model) |
| Shift Position | 0 - 7 levels | CAN data input value | 0:1; 1: 2; 2:3; 3:4; 4: D; 5: N; 6: R; 7: P shift position (There is no 8 input.) Reception from TCM (AT model) |
| Off delay time | OFF, Short, Normal, Long | Body integrated unit setting items | Customize setting |