LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Outback Base, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> LAN Communication System - LAN System (Diagnostics) >> Subaru Select Monitor >> Operation >> Confirmation Of Current Setting

Confirmation Of Current Setting

  1. On the «Main Menu» display screen, select the {Each System Check}.
  2. On the «System Selection Menu» display screen, select the {Integ. Unit mode}.
  3. On the «Integ. Unit mode failure diag» display screen, select the {Current Data Display & Save}.
  4. On the «Current Data Display & Save» display screen, select the {12 Data Display}.
  5. Using the scroll key, scroll the display screen up or down until the desired data is shown.
  6. Display the following item and record the settings.

    Required items for new registration (Except for system not equipped)

CONTENTS CHART

Contents Item to confirm Remarks
Key No. to register 1 2 3 4 Registered ID type
Off delay OFF Long Normal Short Setting for lighting off time
Outside Temp Offset -2°C - +2°C (0.5°C increments) Adjustment of outside temperature
Rr defogger op. mode Normal Continuous Normal: OFF at 15 minutes of operation Continuous: Operations from switch ON to OFF
Wiper deicer op. mode Normal Continuous Normal: OFF at 15 minutes of operation Continuous: Operations from switch ON to OFF, repeats ON for 15 minutes, OFF for 2 minutes
Security Alarm Setup ON OFF ON: Warning device operation possible OFF: Warning device does not operate
Impact Sensor Setup ON OFF ON: Impact sensor operation possible OFF: Impact sensor does not operate Turn OFF for vehicles not equipped with an Impact Sensor
Alarm monitor delay setting ON OFF ON: Monitor after a fixed period of time from reception of the keyless lock signal OFF: Monitor after reception of the keyless lock signal
Lockout prevention ON OFF ON: Lockout prevention operation OFF: Lockout prevention not operated
Impact Sensor Yes No Yes: Impact sensor equipped No: Impact sensor not equipped Always set to no for vehicles not equipped with the impact sensor.
Answer-back buzzer setup ON OFF ON: Answer-back buzzer operation possible OFF: Answer-back buzzer not operated
Hazard answer-back setup ON OFF ON: Hazard answer-back buzzer operation possible OFF: Hazard answer-back buzzer not operated
Ans.-back Buzzer Yes No Yes: Vehicle equipped with answer-back buzzer No: Vehicle not equipped with answer-back buzzer
Passive arming ON OFF ON: Passive arming operation possible OFF: Passive arming not in operation
Belt warning Switch ON OFF ON: All alarms except the first stage not in operation OFF: Belt alarm operation possible
Door open warning (prevention of battery run-out) Yes No Yes: Door interlocked room light goes off when on for 10 minutes consecutively when door is open. No: Room light remains illuminated until door is closed.
A/C ECM setting Yes No Set models with auto A/C to Yes.
Wiper deicer Yes No Yes: Vehicle equipped with wiper deicer No: Vehicle not equipped with wiper deicer
Rear fog light setting Yes No Not supported by North American specifications
Factory initial setting Factory Market Do not change to the factory mode. Set to market when using normally.
scientia non olet · About LEMON Manuals