LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Outback Base, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Fuel Injection System (H4DOTC)) >> SI-DRIVE Selector >> Removal

SI-DRIVE Selector: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground cable from battery.
    Fig 1: Disconnecting Ground Cable From Battery
    G05019586Courtesy of SUBARU OF AMERICA, INC.
  2. Remove the console box. <Ref. to REMOVAL , Glove Box .>
  3. Disconnect the connectors from the SI-DRIVE selector.
    Fig 2: Locating SI-DRIVE Selector Connectors
    G05340197Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the screws securing the upper side of the SI-DRIVE selector to the console box.
    Fig 3: Locating SI-DRIVE Selector Screws
    G05340198Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the screws which secure the cup holder to the console box, then remove the SI-DRIVE selector.
scientia non olet · About LEMON Manuals