LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Outback Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 86 (Clutch System) >> Master Cylinder >> Disassembly

Master Cylinder: Disassembly

WARNING: This page is about a different car, the 2007 Subaru Outback and 2007 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the straight pin and reservoir tank.
    Fig 1: Identifying Straight Pin And Reservoir Tank
    G05342768Courtesy of SUBARU OF AMERICA, INC.
  2. Remove the oil seal.
    Fig 2: Identifying Oil Seal And Master Cylinder
    G05342769Courtesy of SUBARU OF AMERICA, INC.
  3. Move the cylinder boot towards the rear.
    Fig 3: Moving Cylinder Boot Backwards
    G05342770Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the snap ring.
    CAUTION: Be careful when removing the snap ring, to prevent the rod, washer, piston and return spring from flying out.
  5. Remove the clutch damper.
scientia non olet · About LEMON Manuals