LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Outback Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 86 (Clutch System) >> Clutch Switch >> Inspection

Clutch Switch: Inspection

WARNING: This page is about a different car, the 2007 Subaru Outback and 2007 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Make sure that engine does not start with clutch pedal not depressed. If the engine starts, adjust the clutch switch and inspect the starter interlock circuit.
  2. Make sure that engine starts with clutch pedal fully depressed. If the engine does not start, adjust the clutch switch and inspect the starter interlock circuit.
  3. Check the clutch switch for continuity. If the resistance is not at the standard value, replace the switch.
    1. Disconnect the clutch switch connector.
    2. Measure the resistance between terminal 1 and 2 of the switch.
    RESISTANCE SPECIFICATION

    Condition Terminal No. Specified resistance
    When clutch pedal is depressed 1 and 2 Less than 1 Ω
    When the clutch pedal is depressed. 1 and 2 1 MΩ or more

    Clutch switch (Clutch start)

    Fig 1: Checking Clutch Switch Resistance (Clutch Start)
    G05003714Courtesy of SUBARU OF AMERICA, INC.

    Clutch switch (Cruise control)

    Fig 2: Checking Clutch Switch (Cruise Control) Continuity
    G05003713Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals