LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Outback Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 80 (Fuel Injection System (H4DOTC)) >> Fuel Sub Level Sensor >> Installation

Fuel Sub Level Sensor: Installation

WARNING: This page is about a different car, the 2007 Subaru Outback and 2007 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal.

NOTE:
  • Use a new gasket.
  • Make sure the sealing portion is free from fuel or foreign matter before installation.
  • Align the protrusion (A) of gasket to the position shown in the following figure.
  • Align the protrusion (B) of fuel sub level sensor with the cutout portion of fuel sub level sensor upper plate.
  • Tighten the nuts and bolts to the specified torque in the order as shown in the figure.

Tightening torque: 

4.4 N.m (0.45 kgf-m, 3.2 ft-lb) 

Fig 1: Identifying Tightening Sequence Of Fuel Sub Level Sensor Bolts
G05016929Courtesy of SUBARU OF AMERICA, INC.
Fig 2: Locating Fuel Sub Level Sensor Bolts
G05018575Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals