Converter Case: Installation
WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
- Check the appearance of each component and clean them.
- Press-fit the oil seal to converter case using ST.
ST 499587100 OIL SEAL INSTALLER
- Install the differential assembly to the case. < Ref. to INSTALLATION , Front Differential Assembly. >
- Install the right and left side retainers. < Ref. to ADJUSTMENT , Front Differential Assembly. >
- Apply proper amount of liquid gasket to the entire matching surface of converter case.
Liquid gasket: THREE BOND 1215 (Part No. 004403007)
- Install the converter case assembly without damaging bushing and oil seal.
Tightening torque: 41 N.m (4.2 kgf-m, 30.4 ft-lb)
- Install the three converter case mounting bolts (TORX®).
ST 18676AA020 TORX® WRENCH
Tightening torque:
41 N.m (4.2 kgf-m, 30.4 ft-lb)
- Apply proper amount of liquid gasket to the entire oil pan mating surface, and then install it.
Liquid gasket: THREE BOND 1217B (Part No. K0877YA020)
Tightening torque: 5 N.m (0.5 kgf-m, 3.7 ft-lb)
- Install the transmission harness connector to the stay.
- Install the air breather hose. < Ref. to INSTALLATION , Air Breather Hose. >
- Install the ATF filter pipe. < Ref. to INSTALLATION , ATF Filter. >
- Install the oil charge pipe with O-ring. < Ref. to INSTALLATION , Oil Charge Pipe. >
- Install the torque converter assembly. < Ref. to INSTALLATION , Torque Converter Assembly. >
- Install the transmission assembly to the vehicle. < Ref. to INSTALLATION , Automatic Transmission Assembly. >