Master Cylinder: Installation

WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Install the master cylinder to the vehicle body, and connect the clutch pipe to the master cylinder.
NOTE: Check that the pipe is routed properly.

Tightening torque:

T1: 15 N.m (1.5 kgf-m, 10.8 ft-lb)

T2: 18 N.m (1.8 kgf-m, 13.0 ft-lb)

Fig 1: Identifying Master Cylinder And Clutch Pipe
Connect the push rod of the master cylinder to the clutch pedal, and install the clevis pin and snap pin.
NOTE: Apply grease to the clevis pin.

Fig 2: Identifying Snap Pin And Clevis Pin
After bleeding air from the clutch system, ensure that the clutch operates properly.
< Ref. to CLUTCH FLUID AIR BLEEDING . >
Install the air intake chamber. < Ref. to INSTALLATION , Air Intake Chamber. >