LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Outback Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 192 (Lighting System) >> Headlight Assembly >> Disassembly >> Hid Headlight Ballast

Hid Headlight Ballast

WARNING: This page is about a different car, the 2008 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Do not work with wet hands.
  • Because the lighting circuit on the HID headlights uses high voltage, be sure to confirm that the power supply is turned off before operation.
  • Do not leave the headlight without a ballast for extended periods of time. Dust, moisture, etc. entering the headlight may affect its performance.
  1. Disconnect the ground cable from the battery.
  2. Remove the headlight assembly. <Ref. to REMOVAL , Headlight Assembly. >
  3. Remove the back cover.
    Fig 1: Removing Back Cover
    G05663460Courtesy of SUBARU OF AMERICA, INC.
  4. Disconnect the harness connector.
    Fig 2: Disconnecting Harness Connector
    G05663461Courtesy of SUBARU OF AMERICA, INC.
  5. Disconnect the harness connector, loosen the screws, and remove the headlight ballast.
    Fig 3: Identifying Headlight Ballast Screws And Harness Connector
    G05663462Courtesy of SUBARU OF AMERICA, INC.
  6. Disconnect the connector from the headlight ballast.
    Fig 4: Identifying Headlight Ballast Connector
    G05663463Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals