LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Outback Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 182 (LAN Communication System - LAN System (Diagnostics)) >> Subaru Select Monitor >> Operation >> Read Diagnostic Trouble Code (DTC)

Read Diagnostic Trouble Code (DTC)

WARNING: This page is about a different car, the 2008 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Prepare the Subaru Select Monitor kit. <Ref. to PREPARATION TOOL , General Description. >
    Fig 1: Identifying Subaru Select Monitor Kit
    G05663966Courtesy of SUBARU OF AMERICA, INC.
  2. Prepare the personal computer which has been installed the Subaru Select Monitor.
  3. Connect the USB cable between SDI (Subaru Diagnosis Interface) and USB port on the personal computer (dedicated port for the Subaru Select Monitor).
    NOTE: The dedicated port for the Subaru Select Monitor means the USB port which was used to install the Subaru Select Monitor.
  4. Connect the diagnosis cable to SDI.
  5. Connect the SDI to data link connector located in the lower portion of the instrument panel (on the driver's side).
    Fig 2: Identifying Data Link Connector Location
    G05663967Courtesy of SUBARU OF AMERICA, INC.
  6. Start a PC.
  7. Turn the ignition switch to ON (engine OFF), and run the "PC application for Subaru Select Monitor".
  8. Call up DTC and data, then record them.
NOTE: For detailed operation procedure, refer to the help on PC application for Subaru Select Monitor.
scientia non olet · About LEMON Manuals