LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Outback Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 182 (LAN Communication System - LAN System (Diagnostics)) >> Subaru Select Monitor >> Operation >> Confirmation Of Current Setting

Confirmation Of Current Setting

WARNING: This page is about a different car, the 2008 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
  1. On the «Main Menu» display screen, select the {Each System Check}.
  2. On the «System Selection Menu» display screen, select the {Integ. Unit mode}.
  3. On the «Integ. Unit mode failure diag» display screen, select the {Current Data Display & Save}.
  4. Using the scroll key, scroll the display screen up or down until the desired data is shown.
  5. Display the following item and record the settings.

    Required items for new registration (Except for system not equipped)

CONFIRMATION OF CURRENT SETTING

Contents Item to confirm Remarks
Key No. to register 1 2 3 4 Registered ID type
Off delay OFF Long Normal Short Setting for lighting off time
Auto-lock 60, 50, 40, 30, 20 OFF (Unit: seconds)
Rr defogger op. mode Normal Continuous  
Wiper deicer op. mode Normal Continuous Option setting
Security Alarm Setup ON OFF  
Impact Sensor Setup ON OFF Option setting
Alarm monitor delay setting ON OFF  
Lockout prevention ON OFF  
Impact Sensor Yes No Option setting
Answer-back buzzer setup ON OFF  
Hazard answer-back setup ON OFF  
Automatic locking setup ON OFF  
Ans.-back Buzzer Yes No  
Auto locking Yes No  
Initial Keyless Setting Execution -  
Initial button setting Execution -  
Initial Security setting Execution -  
Select unlock switch Select ALL  
Passive arming ON OFF  
Door open warning (prevention of battery run-out) Yes No  
Dome Light Alarm Setting ON OFF  
Belt warning Switch ON OFF Switch the belt warning lighting and the buzzer sound.
A/C ECM setting Yes No Model with auto A/C
Wiper deicer Yes No Option setting
Rear fog light setting Yes No Not supported
Illumination Control On/Off Yes No Not supported
Sedan/Wagon Setting Sedan Wagon  
MT/AT Setting AT MT  
6MT Setting 6MT Other than 6MT  
Destination Setting          
Double Lock On/Off Setting Yes No Not supported
Factory initial setting Factory Market Do not change to factory mode.
Security setting Yes No Not supported