LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Outback Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 182 (LAN Communication System - LAN System (Diagnostics)) >> General Diagnostic Table >> Inspection >> LAN System

LAN System

WARNING: This page is about a different car, the 2008 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
GENERAL DIAGNOSTIC CHART

Item Operation Specifications Note
YES NO
Diagnostic code DTC is not displayed when inspecting all DTCs. DTC is not displayed. Perform the diagnosis according to DTC. -
Engine coolant temperature Check the current data display of ECM, TCM and body integrated unit. Three data value are the same. Same values Inspect LAN system. If engine coolant temperature sensor is not OK, inspect the sensor circuit.
R defogger SW It turns to ON when pressing switch. (Low-speed CAN is OK) Turns to ON. Inspect rear defogger switch. Rear defogger switch is connected with Low-speed CAN.
R defogger output When switch input, it is output. Output Replace the body integrated unit. If not operating with output, check the rear defogger relay.
Door lock SW When locked with door lock switch, it turns to ON. Turns to ON. Inspect door lock switch. The door lock switch is connected to the Low-speed CAN.
Door lock actuator When locked with door lock switch, it is output. Output Replace the body integrated unit. -