LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Outback Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 182 (LAN Communication System - LAN System (Diagnostics)) >> General Diagnostic Table >> Inspection >> Body Integrated Unit

Body Integrated Unit

WARNING: This page is about a different car, the 2008 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
BODY INTEGRATED UNIT SPECIFICATIONS

Item Operation Specifications Note
YES NO
Illumination VR power supply Operate the illumination volume, illumination light is controlled according to the change of voltage on data display. Illumination light is controlled with changing of data. Inspect the illumination volume. -
Fuel level resistance Check the fuel level resistance and fuel level resistance 2. Both resistances are same. Same values Inspect the body integrated unit. Compare the input and output values of body integrated unit.
R wiper SW input When rear wiper SW to ON, data display turns to ON. Turns to ON. Inspect the rear wiper switch. -
R wiper output When rear wiper switch to ON, output signal turns to ON. Turns to ON. Replace the body integrated unit. If not operate with output turned to ON, check the rear wiper motor.
Keyless Entry Keyless entry LOCK/UNLOCK the doors. Operate Inspect the keyless antenna. If the antenna is OK, replace the body integrated unit.
Brake Switch When brake pedal is depressed, it turns to ON. Turns to ON. Inspect the brake switch. -
Shift lock solenoid The shift lock releases when depressing the brake pedal. Released Inspect the shift lock. -
Body integrated unit registration function setting Does Vehicle equipment correspond to setting values? Correspondence Reconfigure the values according to vehicle equipment. -
Customize When changing customize setting, the registration completes correctly. Registered Inspect the body integrated unit. -
Manual mode Switch the shift (UP/DOWN) on Manual mode. Indicator is changed in 1 - 2. Change Inspect the shift lever. -
Function check Each checking item operate correctly. (Except for not equipped) Operate Inspect for nonfunctional actuator. -
Security After locking with keyless entry system and open the door, the security system operates and the horn sounds. Horn sounds. (Security system operates.) Inspect the security system. -