Wagon Model
WARNING: This page is about a different car, the 2007 Subaru Outback and 2007 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
Check that the wedge of the glass lid (front) bracket is in contact at the vehicle forward direction end. At this time, the lid is at the fully open position.
- Install the motor assembly.
- After the installation of the motor assembly, check again that the wedge of glass lid (front) bracket part is in contact at the vehicle forward direction end.
- Connect the harness connector of motor assembly, and then connect the battery ground cable to battery.
- Perform the initialize operation of motor.
- When replacing the motor, fully close the glass once and perform position initialization, because the movement of the glass lid will shift to brink operation.
- When reusing the motor, operate the auto-reverse function five times in a row to shift to the brink operation, then perform the initialization of position.
- Check the operation of sunroof with following table.SUNROOF OPERATION CHECKING CONDITION
Operation Switch position (1) Glass lid (front) and glass lid (rear) closes completely. Close (2) Glass lid (front) tilts up to the ventilating position. Open (3) Glass lid (front) tilts up to top position, and glass lid (rear) opens to just before the completely open position. Open (4) Glass lid (rear) opens completely. Open (5) Glass lid (rear) closes at a position 150 mm (5.91 in) from rear end of the tilted up glass lid (front). Close (6) Glass lid (rear) closes completely, and glass lid (front) stops in the ventilating position. Close (7) Glass lid (front) lowers, and then glass lid (front) and glass lid (rear) closes completely. Close - Install the trim in the reverse order of removal.