5MT Model

WARNING: This page is about a different car, the 2007 Subaru Outback and 2007 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Set the vehicle on a lift.
Disconnect the ground cable from the battery.
Remove the gear shift knob.
Remove the console box. <Ref. to REMOVAL , Console Box .>
Remove the front cover assembly.
Remove the clamp.

Fig 1: Identifying Clamp
Courtesy of SUBARU OF AMERICA, INC.
Remove the bushing and insulator assembly.

Fig 2: Identifying Bushing And Insulator Assembly
Courtesy of SUBARU OF AMERICA, INC.
Remove the harness clamp from the plate assembly.

Fig 3: Identifying Plate Assembly Harness Clamp
Courtesy of SUBARU OF AMERICA, INC.
Remove the plate assembly from the vehicle body.

Fig 4: Identifying Plate Assembly Bolts
Courtesy of SUBARU OF AMERICA, INC.
Lift the vehicle.
Remove the rear exhaust pipe and muffler.
- SOHC and DOHC 2.0 L model <Ref. to REMOVAL , Rear Exhaust Pipe .> <Ref. to REMOVAL , Muffler .>
- DOHC turbo model <Ref. to REMOVAL , Rear Exhaust Pipe .> <Ref. to REMOVAL , Joint Pipe .>
Remove the heat shield cover.

Fig 5: Identifying Heat Shield Cover
Courtesy of SUBARU OF AMERICA, INC.
Remove the stay from transmission bracket.

Fig 6: Identifying Stay And Transmission Bracket
Courtesy of SUBARU OF AMERICA, INC.
Remove the rod from joint.

Fig 7: Removing Rod From Joint
Courtesy of SUBARU OF AMERICA, INC.
Remove the cushion rubber from the vehicle body.

Fig 8: Identifying Cushion Rubber
Courtesy of SUBARU OF AMERICA, INC.
Extract the spring pin and remove the joint.

Fig 9: Identifying Spring Pin
Courtesy of SUBARU OF AMERICA, INC.
Lower the vehicle.
Remove the gear shift lever.

Fig 10: Removing Gear Shift Lever
Courtesy of SUBARU OF AMERICA, INC.